Apart from the Netgear extender red light issue, users are also going bonkers because of the Netgear extender orange light issue while trying to perform mywifiext setup. In case, you are also stuck in the same mess, then the good thing is that the troubleshooting tips mentioned in this article will be of some assistance to you.
However, before we shed light on the needed tips, let us make you aware of the reasons why the LED on your wireless range extender is blinking orange. Becoming acquainted with the factors contributing to the issue at hand will help you to fix it with ease.
What Caused Netgear Extender Orange Light Issue?
Your extender is surrounded by electronic devices and transmitting appliances.
There is too much distance between the range extender and the host router.
The firmware of the wireless extender is running on its outdated version.
You have used a damaged cable to connect the networking devices.
Your Netgear wireless range extender is damaged.
[Resolved] Netgear Extender Orange Light Issue
Relocate the Netgear Extender
Start troubleshooting the Netgear extender orange light issue by changing the location of your wireless range extender. While doing so, make sure that you keep the extender away from cordless phones, washing machines, Bluetooth speakers, treadmills, microwave ovens, refrigerators, televisions, and baby monitors. You will be able to troubleshoot the issue at hand after following this troubleshooting hack. In case, you are not able to, feel free to take the assistance of the following one.
Pull the WiFi Devices Closer
How far is your Netgear wireless range extender kept from the host router? Is it too far to calculate? Well, in that case, you need to reduce the distance between the networking devices. You will be able to do so by unplugging the extender from its existing wall socket and plugging it into the one located near the host router. Make sure that you are not keeping the networking devices too close to each other. Otherwise, the signals emitted from them will clash and cause an accident.
Update the Extender Firmware
The third hack through which you can troubleshoot the Netgear extender orange light issue is by updating the firmware of your device by accessing the Netgear Genie setup wizard. Upgrading the firmware will not just help you to resolve the issue at hand, but also enhance the performance of your extender. If you want to learn more about what performing Netgear extender firmware update can give you, then it is recommended that you refer to the user manual of your networking device.
Replace the Damaged Cable
Did none of the above-given troubleshooting hacks help you to stop the LED on your Netgear extender from blinking orange? Well, it might be because you have connected the networking devices with the help of a damaged cable, as mentioned under the section of reasons. To take care of the problem, consider replacing the damaged cable with a new one. After you are done connecting the networking devices with the help of the new cable, make sure that the connection established is finger-tight.
Purchase a New Extender
Considering you are reading this hack, it means that you are still a victim of the Netgear extender orange light issue. Well, this can only mean one thing, i.e. your Netgear wireless range extender is damaged and needs some repairing. In that case, go to the shop or showroom from where you purchased it. In case the condition of the extender is so bad that it is beyond repair, then it is recommended that you purchase a new extender or get the existing one replaced if it is under warranty. The choice is yours.
Here ends our article written on how to troubleshoot the Netgear extender orange light issue. Although you will be able to resolve the issue at hand after walking through the hacks given above, if you are not able to, set up your networking device from scratch.